Thermal insulation, heat exchangers, piping, pumps and control valves.
Calculate heat loss from pipes and surfaces, outer surface temperature and the economic insulation thickness, with payback and NPV.
Heat loss, surface temperature, thicknessCompare pipe sizes by total cost: Darcy–Weisbach and Colebrook head loss, pumping energy and investment, with payback.
Head loss, velocity, energy by sizeFind the pump operating point on the system curve, compare one pump, two in parallel and two in series, and calculate drive savings versus throttling.
Duty point, parallel, series, VFDPre-size a heat exchanger: heat balance, LMTD, shell-and-tube F factor, fouled U, area, effectiveness and the payback of heat recovery.
LMTD, F factor, area, effectivenessCalculate control valve Cv and Kv for liquids, gases and steam per IEC 60534-2-1, check choked flow and cavitation, and see travel at minimum, normal and maximum flow.
Cv, Kv, choked flow, travel, IEC 60534Calculate total dynamic head from suction, discharge, fittings and equipment, NPSH available and cavitation risk, shaft power, motor size, specific speed and viscous correction.
TDH, NPSH, power, motorImportant notice: Indus Metrics tools produce estimates and pre-sizing results from the data you enter and from published engineering methods. They do not replace design, calculations or reports signed by a licensed professional engineer (PE), nor verification against the applicable codes, standards and regulations, such as OSHA rules and the ASME codes. Material and fuel properties vary: check manufacturer data or your own process analyses before deciding. By using this site you agree to the Terms of Use.
© 2026 Indus Metrics. Found an error? Write to contato@seudominio.com.