Enter cameras by group and the retention period to see how many TB to store, how many drives to buy with RAID, how many recorders to use and whether switch uplinks can carry the traffic.
Pre-sizing and estimating tool: results do not replace design, calculations or reports signed by a licensed professional, nor verification against the applicable codes and standards.
Bars: storage over the retention period, without headroom. Points: group bandwidth on the network.
Required with headroom, compared with the usable capacity of the disks calculated.
The report gathers this page's inputs, results, equations, assumptions and references, with fields for project, engineer and revision. In the print dialog, choose Save as PDF.
Multiply each camera’s bit rate by recording time. A 2 MP H.265 camera at 15 fps produces about 1.15 Mbit/s, or 12.4 GB per day; over 30 days, 0.37 TB. With 24 cameras, 8.9 TB before headroom.
About half the bit rate at the same quality. Smart codecs such as H.265+ reach 30% of the H.264 rate in static scenes but gain little in busy scenes.
RAID 5 is fine for a few drives up to 8 TB. With 12 TB or larger drives, use RAID 6, which survives two failures: rebuilding a large drive takes days.
There is no general federal rule. Retention is set by company policy, insurers, contracts or industry rules (casinos, cannabis, banking). 30 days is common practice.
Important notice: Indus Metrics tools produce estimates and pre-sizing results from the data you enter and from published engineering methods. They do not replace design, calculations or reports signed by a licensed professional engineer (PE), nor verification against the applicable codes, standards and regulations, such as OSHA rules and the ASME codes. Material and fuel properties vary: check manufacturer data or your own process analyses before deciding. By using this site you agree to the Terms of Use.
© 2026 Indus Metrics. Found an error? Write to contato@seudominio.com.