Sheet layout development, press brake bending, oxy-fuel cutting, cylinder gases and argon purging.
Plate layout at the neutral line for concentric and eccentric cone frustums, square-to-round transitions, mitered elbows and 90° or lateral branch saddles. Dimensioned drawing, ordinate table by division, area, weight and plate size.
Cone, elbow, saddleFlat length of parts with several bends from the K-factor (editable table or DIN 6935), natural air-bend radius, material minimum radius, V die opening, minimum flange, tonnage per foot and total, and press brake selection.
K-factor, V die, tonnageCutting and preheat oxygen and fuel gas (acetylene, propane or natural gas) use by steel thickness and cut length, speed, cost per foot and per part, and acetylene manifold size from the withdrawal limit, with editable cutting charts.
Gas use, speed, costContents of oxygen, nitrogen, argon, argon + CO₂ mix, CO₂, dissolved acetylene, hydrogen and helium cylinders in standard cubic feet, pounds and liquid volume, from water capacity, pressure and temperature with compressibility factor Z; duration and cylinders needed for a usage rate.
ft³, lb, liquid, Z factorArgon back purge for stainless pipe welding: volume with or without dams, number of volume changes from the exponential dilution model to the target residual O₂, purge time, gas per joint, joints per cylinder and cost.
Time, changes, gasImportant notice: Indus Metrics tools produce estimates and pre-sizing results from the data you enter and from published engineering methods. They do not replace design, calculations or reports signed by a licensed professional engineer (PE), nor verification against the applicable codes, standards and regulations, such as OSHA rules and the ASME codes. Material and fuel properties vary: check manufacturer data or your own process analyses before deciding. By using this site you agree to the Terms of Use.
© 2026 Indus Metrics. Found an error? Write to contato@seudominio.com.