ABC/XYZ analysis, inventory turnover and carrying cost, economic lot size, safety stock, kanban, dimensional weight, palletizing and truck and container loading.
Paste the package list (length, width, height, quantity and weight) and get total volume, DIM weight from the carrier factor, chargeable weight per shipment or per package, estimated freight and the freight split by item.
DIM weight, chargeable weightEnter the box and pallet (GMA, Euro, Brazil PBR, Asia or custom) and get boxes per layer in column or block patterns, layer count, boxes per pallet, weight and height, cube use and a layer drawing.
Boxes per layer and palletPick the vehicle (20′, 40′ or 40′ HC container, 53′ dry van, European 13.6 m trailer or straight truck) and the load unit (pallets or cartons) and see how many fit by space and by payload, which limit governs, floor, cube and payload use and a floor plan.
Pallets per trailer and containerCalculate the economic order quantity (Harris) and economic production quantity (Taft), the total cost curve, savings versus your current lot and how far setup cost must fall to run small lots.
Setup cost, holding cost, lot sizeCalculate safety stock and reorder point accounting for usage and supplier lead time variability, for continuous or periodic review, and check the service level with a simulation.
Service level, variability, lead time, simulationPaste your item list with cost and usage to classify inventory by ABC (value) and XYZ (demand regularity), see the Pareto chart and the suggested replenishment policy for each class.
Pareto, classes, policy matrixCompute inventory turnover and days of supply, annual carrying cost (capital, storage, insurance, losses), slow-moving stock and the cash freed by lowering coverage, with payback.
Turns, days, capital costImportant notice: Indus Metrics tools produce estimates and pre-sizing results from the data you enter and from published engineering methods. They do not replace design, calculations or reports signed by a licensed professional engineer (PE), nor verification against the applicable codes, standards and regulations, such as OSHA rules and the ASME codes. Material and fuel properties vary: check manufacturer data or your own process analyses before deciding. By using this site you agree to the Terms of Use.
© 2026 Indus Metrics. Found an error? Write to contato@seudominio.com.